[darkbluemurder]

I found it. It is on
www.guitarnuts2.com

But you will have to register there to view.

Cheers Stephan

[buddroyce]

I found it. It is on
www.guitarnuts2.com

But you will have to register there to view.

Cheers Stephan

You sure that link works? I can't seem to get to GuitarNuts2.com do you mean the forums at:

 http://guitarnuts2.proboards.com/ ?

[darkbluemurder]

Yes, that is what I meant.

Cheers Stephan

[kynave]

hi! im trying to convert an HH Ibanez AZ's alter switch to a Push/Push pot, with the same pickup selection capabilties. and replace the pickups with dimarzio Rainmaker and Dreamcatcher pickups. i don't know too much about wiring and such but can anyone help me out with how ill go about achieving this. will i need any different parts and etc. and a diagram will help greatly if can be done.

[buddroyce]

hi! im trying to convert an HH Ibanez AZ's alter switch to a Push/Push pot, with the same pickup selection capabilties. and replace the pickups with dimarzio Rainmaker and Dreamcatcher pickups. i don't know too much about wiring and such but can anyone help me out with how ill go about achieving this. will i need any different parts and etc. and a diagram will help greatly if can be done.

Swapping the Alter switch to a push/pull shouldn't be difficult it it's a standard SPDT switch (it's only got one set of three connectors). The push-pull pot will have two different sets of connectors. One for the rotary pot itself and a set of connectors on the side for the push-pull. Just match the wiring on the original alter switch to the connectors on the side of the push-pull pot. If you get a push-pull with 6 connectors, just use one side.

As for swapping out the pickups. You can just follow the original wiring but swap the red wire on the DiMarzio where the "hot" wire from the Duncan goes(typically the black wire)

[kefka84]

Hello,
I would like to wire a HS3 like a true single coil, permanently, without mini-switch.

Could you please tell me if this is correct?

red > 3 way switch (hot)
black > volume pot (ground)
bare wire > volume pot (ground)
white > not connected, taped alone.
green > not connected, taped alone.

I'm not sure about the red and black, because on this diagram they are reversed.
https://d2emr0qhzqfj88.cloudfront.net/s3fs-public/diagrams/WDGM1_PAFPro_GreenMeanie_HSH_0.pdf

Thanks! 

[darkbluemurder]

That should be correct. If you only get a very weak signal, try green and white instead of red and black.