Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Samuel_385

Pages: [1]
1
The Pickup Place / Re: Is this wiring even possible ?
« on: December 14, 2017, 07:18:37 AM »
Yes, there is a certain arrangement I would like, again I don't know if it's possible.. I would like the 1st position to be the bridge pickup, the middle position both pickup and the 3rd position the neck pickup. I have done this before a while ago but it was a completely different setup.



2
The Pickup Place / Is this wiring even possible ?
« on: December 10, 2017, 09:06:47 PM »
Hello, I've decided to add a Fender humbucker to my neck set up along with my Dimarzio X2N bridge pickup. The problem is I don't know how to wire anything.

Set up is:

- 2 Humbuckers (same colored wires)
- 1 volume
- 1 Tone
- 3 Way Blade.

Does anyone know which wire goes where? Any help would be greatly appreciated..

- Sam

3
The Pickup Place / Re: Trying to wire my Dimarzio Humbucker.
« on: October 23, 2015, 11:15:36 AM »
Ahh, yes I actually did notice that when the guitar was sitting by itself there was a noise coming from it that had me concerned but when I hit the strings it sounded amazing. I will solder those two wires to the back of the volume tonight. You rock bro! appreciate the help

Alphonse

4
The Pickup Place / Re: Trying to wire my Dimarzio Humbucker.
« on: October 22, 2015, 10:33:27 PM »
Hey Stephan, thanks for your reply man. I just soldered everything as you suggested and it works great! This was my first time wiring a guitar so I'm surprised it was that easy.. Besides the 4 colored wires there's a bare wire, am I suppose to do anything with that? Also there's a wire coming up from the back springs of the guitar, what's that for?

Alphonse

5
The Pickup Place / Trying to wire my Dimarzio Humbucker.
« on: October 21, 2015, 11:18:53 PM »
Hey, I am trying to wire my Dimarzio X2N into a fender 3 single coil. I ordered a new pickguard with just a humbucker slot, Volume knob and 5 way switch. All I want is the volume knob and the pickup.. is that possible? If so could you explain how I would wire that? Thanks a lot,

Alphonse



Pages: [1]