1

The Pickup Place / Re: Super Dist Q

« on: August 03, 2019, 03:12:39 PM »

HTF - your initial idea was spot on. Got the colors correct, and all is well.

Thanks!

2

The Pickup Place / Re: Super Dist Q

« on: August 03, 2019, 03:12:03 PM »

The wiring diagrams available on the DiMarzio site should lay it out for most any config. Have you already checked there?

Yeah - too many choices... too complicated 

3

The Pickup Place / Re: Super Dist Q

« on: July 27, 2019, 11:24:34 PM »

Aha! That could explain why I all of a sudden have some hum.

So, found this:

(below)

Where TA is first...

Does this mean that I need to go BL > GR, WH > WH, GR > RED, RED > BL?

Will be easy enough if yes.

What's M.P., btw?

Thank you!

4

The Pickup Place / Super Dist Q

« on: July 27, 2019, 05:58:07 PM »

Hi everyone

I am replacing the bridge humbucker in my '96 Tom Anderson Drop-Top. I have a Super Dist, that I have wired as the TA p/u was wired - real easy, r > r, bl > bl, etc.

The guitar is plugged into my hi-gain Marshall. When I lightly run a screwdriver over the poles of the TA p/u, I hear a that good 'ol scratchy noise... the noise sounds the same on poles in both bobbins.

Not so with the SDist; one bobbin sounds like the TA, and the other has some, but not nearly as much.

Does anyone know if this is normal? Would someone mind checking? My soldering is not exactly world-class, so it's possible there is something awry there.

Thanks in advance.