1

The Pickup Place / Gold Hex's For SDS-1 p/u's

« on: April 23, 2022, 12:11:53 PM »

Hi all,,, Dimarzio is not shipping only polepieces at this time, so I'm looking for a source of (according to Dmz) 10-32 1" gold polepieces for my SDS-1's. What I'm not certain of if they're fine or coarse threading.
Thnx in advance for all assistance~

2

The Pickup Place / Ares 58, 61 & 67 pups...

« on: October 28, 2019, 12:43:36 AM »

In a nutshell what are the sonic differences between these 3, & what positions are they each best suited for?
Thanks, kenny
🕉

3

The Pickup Place / Re: Set Screws For Older SDS-1 pup?

« on: May 15, 2019, 06:46:11 PM »

Thanks!  I won't knock myself online~~

4

The Pickup Place / Set Screws For Older SDS-1 pup?

« on: May 15, 2019, 06:34:21 PM »

Hi all~  thinking of putting gold set screws in my pup, & was wondering what size & length, etc., & could I expect a change in sound from the 40 yr. old screws that are in there now?  Where to buy them?
Thanks a million~~

5

The Pickup Place / P90 Choices

« on: May 11, 2019, 10:49:37 PM »

Sorry if i posted twice:

SDS-1 woes aside, which P90's do folks around here like for bridge & neck in a rosewood neck Strat with new Blender Pot harness. Since my middle SDS1 is kinda hot @ 8.6k, I'm thinking of some Vintage SD's, or some Hot Toneriders my pal raves about. Fralin, Antiquities & Lollars are probably only a little bit better but at a big price diff. I don't want anything too dark & murky.... not too hot & muddy. But I'm open to suggestions & eager to hear from ya'll.
Thanks

6

The Pickup Place / Re: Older 70's Dimarzio SDS1 wiring question~~

« on: May 11, 2019, 06:15:04 PM »

The HS's don't have the hex screws like mine.
Thanks

7

The Pickup Place / Older 70's Dimarzio SDS1 wiring question~~

« on: May 11, 2019, 12:50:52 AM »

 Older 70's Dimarzio SDS1 wiring question~~
Hi. I recently picked up an older SDS1 that has a total of 4 wires: bare, black, green & white. It will be going into the middle position opposite 2 P90's. 10 different blogs have 15 differing answers as to what's what. I was under the impression that it was a single coil p/u, so I'm a little confused. Bare is obviously ground, but what about the other 3? Is one left taped off, & is there the option that there are two hots, with one of them being a lower output lead?
I'm lost...the p/u is in transit so I can't measure stuff. But what's the general layout of my four leads?
Thanks all~~